Le 15 mars 2016, 07:10 dans Humeurs • 0
The hopper interior can also have a release coating or smooth finish to aid with the downward flow of difficult materials. Agitator. If material doesn’t flow easily into the feed Lag Screw, especially when the supply hopper has a capacity larger than several cubic feet, the material in the hopper or trough may need to be agitated. This agitation can be internal or external, and each has pros and cons. An internal agitator — such as the large horizontal screw agitator shown in Figure 1 — can be very good at encouraging material flow, but it can make hopper cleanout more difficult and time-consuming.
A spiral agriculturalist for administration difficult actual can crave a appropriate augment spiral architecture and can be configured in abundant means to ensure that the augment spiral is continuously abounding with actual of a constant aggregate density. For instance, the agriculturalist can accept one augment spiral with no advocate (Figure 2a), one or two screws with a vibrated canal or a beating flexible-wall hopper, one spiral with a concentric advocate that operates at the aforementioned or a altered acceleration (Figure 2b), or one spiral with one or two agitators army aloft it (Figure 2c). Motor drive.
A vertical, top-mounted agitator can make connecting the hopper to upstream process equipment awkward or difficult. A hopper or trough with externally applied vibrators or pulsing flexible hopper walls can be effective at encouraging flow of difficult materials. In any case, the agitation must also condition the material — that is, help promote and maintain a uniform material bulk density — to provide accurate volumetric feeding. Screw and agitator configurations.
A screw feeder for handling difficult material can require a special feed screw design and can be configured in numerous ways to ensure that the feed screw is continuously filled with material of a consistent bulk density. For instance, the feeder can have one feed screw with no agitator (Figure 2a), one or two screws with a vibrated trough or a pulsing flexible-wall hopper, one screw with a concentric agitator that operates at the same or a different speed (Figure 2b), or one screw with one or two agitators mounted above it (Figure 2c). Motor drive.
The motor drive typically uses a motor and gears to drive the feed screw or agitator. A drive with steel gears will be significantly stronger and more durable than one with synthetic gears.
The feeder can have one or more drives, depending on the Concrete Screws and agitator configuration and the application.